Evaluation of Barium Sulfate (Barite) Solubility Using Different Chelating Agents at a High Temperature

Document Type : Research Paper

Authors

1 King Fahd University of Petroleum and Minerals

2 King Fahd University of Petroleum & Minerals,

3 King Fahd University of Petroleum & Minerals

Abstract

Barium sulfate (barite) is one of the widely used weighting materials in the preparation of drilling fluid for deep oil and gas wells. Barite is not soluble in the regular solvents; such as, hydrochloric acid (HCl) and other acids. Therefore, in this study, we focused on evaluating the dissolution of the industrial barite particles in different chelating agents. Chelating agents; such as, diethylene triamine penta acetic (DTPA), ethylene diamine tetra acetic (EDTA), and hydroxyethyl ethylene diamine tri acetic (HEDTA) acids with high and low pH values were used in this study. The effect of the base of chelating agents, namely alkali and alkali earth hydroxides, on the dissolution of barite was also investigated. For the first time, the optimum pH, concentration, and base (sodium or potassium) of chelating agents which yielded the maximum dissolution were investigated in this study at a high temperature. Previous studies did not consider the wellbore constraints during their experiments and they used chelating agent volume to barite weight ratio, which could not be implemented in the real wells. In this study and for the first time, we considered the wellbore volume (chelating agent volume that can be used) and the barite weight (filter cake) during the dissolution experiments. Based on the results obtained from this study, potassium base DTPA-K5 and EDTA-K4 of a concentration of 20 wt.% were found to be the most effective chelating agents to dissolve barite. The solubility of barite was found to be 26.8 g/L in a solution containing 20 wt.% of DTPA-K5 and 25.6 g/L in a solution containing 20 wt.% of EDTA-K4 during a soaking time of 24 hrs and a pH value above 11 at 200°F.

Keywords


Fink J. K., “Petroleum Engineer’s Guide to Oil Field Chemicals and Fluids,” Waltham, MA: Gulf Professional Pub., 2012.
Bageri B. S., Al-Majed A. A., Al-Mutairi S. H., Ul-Hamid A., et al., “Evaluation of Filter Cake Mineralogy in Extended Reach and Maximum Reservoir Contact Wells in Sandstone Reservoirs,” SPE/IADC163519, Presented at SPE/IADC Drilling Conference, Amsterdam, The Netherlands, 2013, 5-7 March.
Dunn K., Daniel E., Shuler P. J., Chen H. J. et al., “Mechanisms of Surface Precipitation and Dissolution of Barite: A Morphology Approach.,” J. Colloid Interface Science, 1999, 214, 427–437.
Clemmit A. F., Ballance D. C., and Hunton A. G., “The Dissolution of Scales in Oilfield Systems,” SPE-14010, Presented at Offshore Eur. Aberdeen, United Kingdom, 1985, 10-13 Sept.
Morris R. L. and Paul J. M., “Method for Removing Sulfate Scale,” US Patent, 1990.
Lakatos I., Lakatos-Szabo J., and Kosztin B., “Optimization of Barite Dissolvers by Organic Acids and pH Regulation,” SPE 74667, Presented at International Symposium on Oilfield Scale, Aberdeen, United Kingdom, 2002, 30-31 January.
Lakatos I., Lakatos-Szabo J., and Kosztin B., “Comparative Study of Different Barite Dissolvers: Technical and Economic Aspects,” SPE 73719, Presented at International Symposium and Exhibition on Formation Damage Control, Lafayette, Louisiana, 2002, 20-21 February.
Putnis C. V., Kowacz M., and Putnis A., “The Mechanism and Kinetics of DTPA-Promoted Dissolution of Barite,” Appl. Geochemistry, 2008, 23, 2778–2788.
Putnis A., Putnis C. V., and Paul J. M., “The Efficiency of a DTPA-based Solvent in the Dissolution of Barium Sulfate Scale Deposits,” SPE 29094, Presented at SPE International Symposium on Oilfield Chemistry, 14-17 February, 1995, 773-785.
Nasr-El-Din H. A., Al-Mutairi S. H., Al-Hajji H. H., and Lynn J. D., “Evaluation of a New Barite Dissolver: Lab Studies,” SPE 86501, Presented at SPE International Symposium on Exhibition and Formation Damage Control, 2004,18-20 February.
“Akzo Nobel Dissolvine Product Guide 10-2012” [Online]. Available: (https://www.akzonobel.com/dissolvine/system/images/AkzoNobel_Dissolvine_Product_Guide_10-2012_tcm108-37894.pdf).
Bageri B. S., Mahmoud M. A., Al-Mutairi S. H., and Abdulraheem A., “Filter Cake Porosity and Permeability Profile along the Horizontal Well and,” International Petroleum Technology Conference held in Doha, Qatar, 2015, 6-9 December.
Bageri B. S., Mahmoud M., Al-Mutairi S. H., and Abdulraheem A., “Effect of Sand Content on the Filter Cake Properties and Removal During Drilling Maximum Reservoir Contact Wells in Sandstone Reservoir,” J. Energy Resour. Technol., 2015, 138, 032901.
Fred C. and Fogler H., “The Influence of Chelating Agents on the Kinetics of Calcite Dissolution,” J. Colloid Interface Sci., 1998, 204, 187–197.
Mahmoud M. A., Nasr-El-Din H. A., Wolf C. De, and James N., “Stimulation of Carbonate Reservoirs Using GLDA (Chelating Agent) Solutions,” SPE-132286, Presented at Trinidad and Tobago Energy Resources Conference, Port of Spain, Trinidad, 2010, 27-30 June.
Ramaswamy V., Vimalathithan R. M., and Ponnusamy V., “Synthesis of Well Dispersed, Elliptical Shaped Barium Sulfate Nanoparticles via Water-chloroform Mixed Solvent,” Arch. Phys. Res., 2010, 1, 217–226.
Povnnennykh A. S., “The Use of Infrared Spectra for the Determination of Minerals,” Am. Mineral., 1978, 63, 956–959.
Dimova M., Panczer G., and Gaft M., “Spectroscopic Study of Barite from the Kremikovtsi Deposit (Bulgaria) with Implication for its Origin,” Geol. Anal. Balk. Poluostrva, 2006, 67, 101–108.
Lane M. D., “Mid-infrared Emission Spectroscopy of Sulfate and Sulfate-bearing Minerals,” Am. Mineral., 2007, 92, 1–18.
Myneni S. C. B., Traina S. J., Waychunas G. a., and Logan T. J., “Vibrational Spectroscopy of Functional Group Chemistry and Arsenate Coordination in Ettringite,” Geochim. Cosmochim. Acta, 1998, 62, 3499–3514.
Lugwisha E. H. J., “Identification of Clay Minerals of the Eastern Southern Region of Lake Victoria by Ethylene Glycol and Heat: X-Ray Diffraction and Infrared Spectroscopy Studies,” Tanz. J. Sci., 2011, 37, 167–178.
Shawabkeh R. A., “Synthesis and Characterization of Activated Carbo-aluminosilicate Material from Oil Shale,” Journal of Microporous and Mesoporous Materials, 2004, 75, 107–114.
Saikia B. J. and Parthasarathy G., “Fourier Transform Infrared Spectroscopic Characterization of Kaolinite from Assam and Meghalaya, Northeastern India,” J. Mod. Phys., 2010, 01, 206–210.
Mendelovici E., Frost R. L., and Kloprogge J. T., “Modification of Chrysotile Surface by Organosilanes: An IR–photoacoustic Spectroscopy Study,” J. Colloid Interface Sci., 2001, 238, 273–278.
Frost R., Martens W., Williams P., and Kloprogge J., “Raman and Infrared Spectroscopic Study of the Vivianite-Group Phosphates Vivianite, Baricite and Bobierrite,” Mineral. Mag., 2002, 66, 1063–1073.
Palanivel R. and Velraj, G., “FTIR and FT-Raman Spectroscopic Studies of Fired Clay Artifacts Recently Excavated in Tamilnadu, India,” Indian J. Pure Appl. Phys., 2007, 45, 501–508.
Kloprogge J. T., Hickey L., and Frost R. L., “FT-Raman and FT-IR Spectroscopic Study of Synthetic Mg/Zn/Al-Hydrotalcites,” J. Raman Spectrosc., 2004, 35, 967–974.
Simonescu C. M., “Application of FTIR Spectroscopy in Environmental Studies,” Adv. Asp. Spectrosc., 2012, 2, 49-84.
Yang Y., Xiang H. W., Xu Y. Y., Bai L., et al., “Effect of Potassium Promoter on Precipitated Iron-manganese Catalyst for Fischer-Tropsch Synthesis,” Appl. Catal. A: Gen., 2004, 266, 181-194.