Poly (Vinylidene Fluride) Membrane Preparation and Characterization: Effects of Mixed Solvents and PEG Molecular Weight

Document Type: Research Paper

Authors

1 Research Institute of Petroleum Industry and Iran university of science and technology

2 RIPI

3 Iran university of sicence and technology

Abstract

In this study, polyvinylidene fluoride (PVDF) ultrafiltration membranes were prepared via immersion precipitation method using a mixture of two solvents triethyl phosphate (TEP) and dimethylacetamide (DMAc), which had different affinities with the nonsolvent (water). Properties of the prepared membranes were characterized using scanning electron microscope (SEM) and contact angle and membrane porosity measurements. The prepared membranes were further investigated in terms of pure water flux and BSA rejection in cross flow filtration experiments. The results showed that by using a mixture of DMAc and TEP as solvent and changing the mixed solvent composition, membranes with different morphologies from sponge-like to macrovoid containing were obtained.
Maximum flux of the prepared membranes with different solvent mixing ratios was obtained for the one with 60%wt TEP in the casting solution of PVDF/TEP-DMAc/ PEG which equals to 76.8 lm-2h-1. The effect of addition of polyethylene glycol with different molecular weight on morphology and performance of the membranes has also been discussed.

Keywords


      [1]     Loahardjo N., Xie X., Yin P., and Morrow N. R., “Low Salinity Water flooding of A Reservoir Rock,” Paper SCA2007-29-Presentated at the International Symposium of the Society of Core Analysts, Calgary, Canada September 10-12, 2007.

      [2]     Austad T., Rezaei Doust A., and Puntervold T., “Chemical Mechanism of Low Salinity Water Flooding in Sandstone Reservoirs,” Paper SPE 129767-PP. Presented at the SPE Improved Oil Recovery Symposium, Tulsa, Oklahoma, USA, 2010.

      [3]     Salathiel R. A., “Oil Recovery by Surface Film Drainage in Mixed Wettability Rocks,” Journal of Petroleum Technology, 1973, 25, 1216-1224.

      [4]     Jadhunandan P. and Morrow N. R., “Effect of Wettability on Water flooding Recovery for Crude Oil/Brine/Rock Systems,” SPE Reservoir Engineering, 1995, 10, 40-46.

      [5]     Tong Z. X., Morrow N. R., and Xie X., “Spontaneous Imbibition for Mixed-wett-ability States in Sandstones Induced by Adsorption from Crude Oil,” Journal of Petroleum Science and Engineering,2003, 39, 351-361.

      [6]     Ligthelm D. J., Gronsveld J., Hofman J. P., Brussee N. J., et al., “Novel Water Flooding Strategy by Manipulation of Injection Brine Composition,” Paper SPE 119835. Presented at the 2009 SPE EUROPEC/ EAGE Annual Conference and Exhibition, Amsterdam, The Netherlands, 2009.

      [7]     Rezaei Doust A., Puntervold T., and Austad T., “A Discussion of the Low Salinity EOR Potential for a North Sea Sandstone Field,” Paper SPE 134459. Presented at the SPE Annual Technical Conference and Exhibition, Florence, Italy, 2010.

      [8]     Alotaibi M. B., Azmy R. M., and Nasr-El-Din H. A., “A Comprehensive EOR Study Using Low Salinity Water in Sandstone Reservoirs,” Paper SPE 129976. Presented at the SPE Improved Oil Recovery Symposium, Tulsa, Oklahoma, USA, 2010.

      [9]     Lager A., Webb K. J., Black C. J. J., Singleton M., et al., “Low Salinity Oil Recovery: An Experimental Investigation,” Paper SCA2006-36. Presented at the International Symposium of the Society of Core Analysts Trondheim, Norway, 2006.

    [10]    Boston W. G., Brandner C. F., and Foster W. R., “Recovery of Oil by Water flooding from an Argil-laceous, Oil-containing Subterra-nean Formation,” US Patent 3740956, October 1969.

    [11]    Tie H. and Morrow N., “Low-Flood-Rate Residual Saturation in Carbonate Rocks,” Paper SPE 10470 Presented at the SPE International Petroleum Technology Con-ference, Doha, 2005.

    [12]    Morrow N. R., “Wettability and its Effect on Oil Recovery,” Journal of Petroleum Technology, 1990,42, 1476-1484.

    [13]    Anderson W. G., “Wettability Literature Survey-Part 2: Wettability Measurement,” Journal of Petroleum Technology, 1986, 38, 1246-1262.

         [14]         Madsen L., Grahl-Madsen L., Grøn C., Lind Ida., “Adsorption of Polar Aromatic Hydrocarbons on Synthetic Calcite,” Organic Geochemistry, 1996, 24, 1151-1155.

    [15]    Thomas M. M., Clouse J. A., and Longo J. M., “Adsorption of Organic Compounds on Carbonate Minerals: 1. Model Com-pounds and Their Influence on Mineral Wettability,” Chemical Geology, 1993, 109, 201-213.

    [16]    Zou L., Han B., Yan H., Kasperski K. L., et al., “Enthalpy of Adsorption and Isotherms for Adsorption of Naphthenic Acid onto Clays,” Journal of Colloid & Interface Science, 1997, 190, 472-475.

    [17]    Legens C., Toulhoat H., Cuiec L., Villieras F., et al., “Wettability Change Related to the Adsorption of Organic Acids on Calcite: Experimental and Ab Initio Computational Studies,” Paper SPE 49319 Presented at the SPE Annual Technical Conference and Exhibi-tion, New Orleans, USA, 1998.

    [18]    Zhang P. and Austad T., “The Relative Effects of Acid Number and Temperature on Chalk Wettability,” Paper SPE 92999 Presented at the SPE International Sympo-sium on Oilfield Chemistry, Houston, USA, 2005.