Single Step and Non-Catalytic Process for Formaldehyde Production from Methane using Microchannel Reactor: Theoretical Analysis

Document Type: Research Paper

Authors

1 Department of Chemical Engineering, Amirkabir University of Technology, Tehran, Iran.

2 Amirkabir university of technology

10.22078/jpst.2019.3626.1576

Abstract

Conventionally, methane is reformed into syngas, and subsequently converted into C1-oxygenates (methanol and formaldehyde). A novel option is the catalyst-free single-step conversion of methane to C1-oxygenates. This study presents a comprehensive model of methane partial oxidation to formaldehyde as an intermediate chemical species in methane oxidation process using microreactor. The dependency of C1-oxygenates yield on operating parameters is crucial. Therefore a representative mathematical model is constructed and solved in order to investigate the effect of operating temperature, feed flow-rate, and composition on the formaldehyde yield. Fifty-four coupled of differential equations are solved by finite element method. Moreover, to simulate the process, GRI-Mech 3.0 is employed as the reaction kinetics. A good agreement was achieved when the model results were compared with experimental data from the literature in terms of formaldehyde concentration and methane conversion. Finally, results of the study are presented and discussed on the basis of a major reaction pathway proposed in this study for methane oxidation at low temperature, and the important design criteria are presented. With respect to the model results, 5.5% yield for formaldehyde per one pass of microreactor was achieved at the operating condition of T = 1000 K and O2/CH4 ratio = 17.

Keywords


REFERENCES

Zakaria Z. and Kamarudin S. K., “Direct Conversion Technologies of Methane to Methanol: An Overview,” Renewable and Sustainable Energy Reviews, 2016, 65, 250-261.

Holmen A., “Direct Conversion of Methane to fuels and Chemicals,” Catalysis Today, 2009, 142(1), 2-8.

Nasr J. and Abrishami A., “Energy Management and Process Improvement of Methanol Production,” Journal of Petroleum Science and Technology, 2012, 2(2), 33-39.

Maklavany D. M., Shariati A., Khosravi-Nikou M. R., and Roozbehani B., “Hydrogen Production via Low Temperature Water Gas Shift Reaction: Kinetic Study,” Mathematical Modeling, Simulation and Optimization of Catalytic Fixed Bed Reactor using gPROMS. Chemical Product and Process Modeling, 2017, 12(3), 3-23.

Ghodoosi F., Khosravi-Nikou M. R., and Shariati A., “Mathematical Modeling of Reverse Water-Gas Shift Reaction in a Fixed-Bed Reactor,” Chemical Engineering and Technology, 2017, 40(3), 598-607.

Zhang J., Burklé-Vitzthum V., and Marquaire P., “NO 2-promoted Oxidation of Methane to Formaldehyde at Very Short Residence Time–Part II: Kinetic Modeling,” Chemical Engineering Journal, 2012, 197, 123-134.

Arutyunov V., “Low-scale Direct Methane to Methanol-Modern Status and Future Prospects,” Catalysis Today, 2013, 215, 243-250.

Zhang Q., He D., and Zhu Q., “Recent Progress in Direct Partial Oxidation of Methane to Methanol,” Journal of Natural Gas Chemistry, 2003, 12(2), 81-89.

Koo K., “Autothermal Reforming of Methane to Syngas for Fischer–Tropsch Synthesis with Promoted Palladium and a Fast Start-up Device,” Research on Chemical Intermediates, 2008, 34(8), 803-810.

Moshrefi M. M., Rashidi F., and Bozorgzadeh H. R., “Use of a DC Discharge in a Plasma Reactor with a Rotating Ground Electrode for Production of Synthesis Gas by Partial Oxidation of Methane,” Research on Chemical Intermediates, 2015, 41(9), 5941-5959.

Foulds, G. and B. Gray, “Homogeneous Gas-phase Partial Oxidation of Methane to Methanol and Formaldehyde,” Fuel Processing Technology, 1995, 42(2), 129-150.

Thomas D. J., Willi R., and Baiker A., “Partial Oxidation of Methane: the Role of Surface Reactions,” Industrial and Engineering Chemistry Research Journal, 1992, 31(10), 2272-2278.

Zhang J., “Direct Conversion of Methane in Formaldehyde at Very Short Residence Time,” Chemical Engineering Science, 2011, 66(24), 6331-6340.

Benlounes O., “Direct Oxidation of Methane to Oxygenates over Heteropolyanions,” Journal of Natural Gas Chemistry, 2008, 17(3), 309-312.

De Vekki A. and Marakaev S., “Catalytic Partial Oxidation of Methane to Formaldehyde,” Russian Journal of Applied Chemistry, 2009, 82(4), 521-536.

Wang Y., “Selective Oxidation of Hydrocarbons Catalyzed by Iron-containing Heterogeneous Catalysts,” Research on Chemical Intermediates, 2006, 32(3), 235-251.

Jun J. H., Lee T. J., Lim T. H., Nam S. W., et al., “Nickel-calcium Phosphate/hydroxyapatite Catalysts for Partial Oxidation of Methane to Syngas: Effect of Composition,” Korean Journal of Chemical Engineering, 2004, 21(1), 140-146.

Liu Z. W., Roh H. S., Jun K. W., Park S. E., and Song T. Y., “Partial Oxidation of Methane over Ni/Ce-Zro2/θ-Al2O3,” Korean Journal of Chemical Engineering, 2002, 19(5), 742-748.

Liu Z. W., Jun K. W., Roh H. S., Park S. E., and Oh Y. S., “Partial Oxidation of Methane over Nickel Catalysts Supported on Various Aluminas,” Korean Journal of Chemical Engineering, 2002, 19(5), 735-741.

Han Z. S., “Preparation and Effect of Mo-V-Cr-Bi-Si Oxide Catalysts on Controlled Oxidation of Methane to Methanol and Formaldehyde,” Korean Journal of Chemical Engineering, 1998, 15(5), 496-499.

Bozorgzadeh H. R., “Catalytic and Non-catalytic Conversion of Methane to C2 Hydrocarbons in a Low Temperature Plasma,” Journal of Petroleum Science and Technology, 2015, 5(1), 69-78.

Tabata K., “Activation of Methane by Oxygen and Nitrogen Oxides,” Catalysis Reviews, 2002, 44(1), 1-58.

Görke O., Pfeifer P., and Schubert K., “Highly Selective Methanation by the Use of a Microchannel Reactor,” Catalysis today, 2005, 110(1), 132-139.

Michalkiewicz B., “Partial Oxidation of Methane to Formaldehyde and Methanol Using Molecular Oxygen over Fe-ZSM-5,” Applied Catalysis A: General, 2004, 277(1–2), 147-153.

Duan C., Luo M., and Xing X., “High-rate Conversion of Methane to Methanol by Methylosinus trichosporium OB3b,” Bioresource Technology, 2011, 102(15), 7349-7353.

Lee S. G. , “Optimization of Methanol Biosynthesis from Methane using Methylosinus Trichosporium OB3b,” Biotechnology Letters, 2004, 26(11), 947-950.

Villa K., Murcia-López S., Andreu T., and Morante J. R., “Mesoporous WO3 Photocatalyst for the Partial Oxidation of Methane to Methanol Using Electron Scavengers,” Applied Catalysis B: Environmental, 2015, 163, 150-155.

Rodríguez-Guerra Y., Gerling L. A., LoĢpez-Guajardo E. A., Lozano-García F. J., and et al., “Design of Micro- and Milli-Channel Heat Exchanger Reactors for Homogeneous Exothermic Reactions in the Laminar Regime,” Industrial and Engineering Chemistry Research, 2016, 55(22), 6435-6442.

Kshetrimayum K. S., “CFD Simulation of Microchannel Reactor Block for Fischer–Tropsch Synthesis: Effect of Coolant Type and Wall Boiling Condition on Reactor Temperature,” Industrial and Engineering Chemistry Research Journal, 2016, 55(3), 543-554.

Anxionnaz Z., “Heat Exchanger/reactors (HEX Reactors): Concepts, Technologies: State-of-the-art,” Chemical Engineering and Processing: Process Intensification, 2008, 47(12), 2029-2050.

Kristal J., “Practical Engineering Aspects of Catalysis in Microreactors,” Research on Chemical Intermediates, 2015, 41(12), 9357-9371.

Su M., “Synthesis of Highly Monodisperse Silica Nanoparticles in the Microreactor System,” Korean Journal of Chemical Engineering, 2017, 34(2), 484-494.

Burkle-Vitzthum V., “Annular Flow Microreactor: An Efficient Tool for Kinetic Studies in Gas Phase at very Short Residence Times,” Chemical Engineering Research and Design, 2015, 94, 611-623.

Frenklach M., Bowman C. T., Smith G. P., and Gardiner W. C., “World Wide Web location http://www. me. berkeley. edu. gri_mech,” Version 1999, 3(0).

Balaji S. and Lakshminarayanan S., “Improved Design of Microchannel Plate Geometry for Uniform Flow Distribution,” The Canadian Journal of Chemical Engineering, 2006, 84(6), 715-721.

Commenge J., “Optimal Design for Flow Uniformity in Microchannel Reactors”, AIChE Journal, 2002, 48(2), 345-358.

Bird R. B., Stewart W. E., and Lightfoot E. N., “Transport Phenomena (2nd ed.),” John Wiley and Sons, 2007, 1-897.

Belfiore L. A., Way J. J., and Zhang L., “Transport Phenomena for Chemical Reactor Design (1st ed.),” Kirk-Othmer Encyclopedia of Chemical Technology, 2000, 1-865.

Glarborg P., “PSR: A FORTRAN Program for Modeling Well-stirred Reactors,” Sandia Report SAND86-8209, 1986.

Alam F. E., “Influence of Trace Nitrogen Oxides on Natural Gas Oxidation: Flow Reactor Measurements and Kinetic Modeling,” Journal of Energy and Fuels, 2016, 31(3), 2360-2369.

Da Silva M. J., “Synthesis of Methanol from Methane: Challenges and Advances on the Multi-step (Syngas) and One-step Routes (DMTM),” Fuel Processing Technology Journal, 2016, 145, 42-61.

Rasmussen C. L., Jakobsen J. G., and Glarborg P., “Experimental Measurements and Kinetic Modeling of CH4/O2 and CH4/C2H6/O2 Conversion at High Pressure,” International Journal of Chemical Kinetics, 2008, 40(12), 778-807.

Aasberg-Petersen K., Hansen J. H. B., Christensen T. S., Dybkjaer I., Christensen P. and et al., “Technologies for Large-scale Gas Conversion,” Applied Catalysis A: General, 2001, 221(1), 379-387.